[RESOLVED] Teredo Tunneling

[squid13]

I'm using Windows 7 Pro 64bit. I was in my device manager and under Network adapter is a yellow exclamation mark next to Teredo Tunneling Pseudo-Interface and says, This device cannot start Code 10. I know this has something to do with IPV6 but what do I have to do to clear this up?

[Midknyte]

It should be the same or similar to the way you do it in Vista:

http://www.mydigitallife.info/2007/0...ling-in-vista/

[squid13]

That tells you how to turn it off, I'd like to start it up to clear the mark. I tried to reinstall the driver but it says it ran into a problem and it won't install code 10.

[Midknyte]

You actually want to keep it? So you use IPv6 and/or Homegroups? If not, you're better off without it.

Are you running a firewall? If so, you need to enable/allow IPv6.

[squid13]

I found the problem. I was testing out Zone Alarm Pro and IPV6 was disabled in there. I enabled it to see if it would fix it and all was OK. Thank you for your replies.

[Midknyte]

ZA is known to block IPv6, that's why I asked if you had a firewall.

[SuperSparks]

And when it isn't blocking IPv6, it's blocking something else ZA is a royal pain, and I'd recommend getting rid of it.

[squid13]

I did and it's gone now but I had a royal pain getting rid of all the stuff left behind.