|
-
October 7th, 2009, 01:29 AM
#1
[RESOLVED] Bad PSU or what?
I got back home from work and when I got on my computer, it was hung, non responsive. CTRL+ALT+DEL wouldn't do nothing. I hard-booted it and this time, it got stuck on the ASUS welcome screen. Usually, it would stay there for about 3 seconds.
So now, I turned it off, unplugged the PSU, plugged it back in and pushed the power button on in the front panel of the case. This is when I took it seriously . It started blinking on me every 2 seconds or so. Blinking means, the power would come on and all the fans would turn on for about a second and then it would turn it self off. It would repeat the patern every 1.5-2 seconds.
I started unplugging all the wires/cables to no avail. Have 4 hard drives in there so I was thinking that maybe there isn't enough power. But even after disconnecting everything, it still blinks. Removed and placed back in the mobo 24 pin power cable, did the same with the 2 RAM sticks. Nothing seems to matter.
I don't have another 24 pin PSU to test it with.
What do you think it might be???
The timing couldn't be worse.
Thanks in advance for any help.
my code doesn't break, it only bends
-
October 7th, 2009, 01:34 AM
#2
Sure seems like the PSU. The only other thing you might check is for bad caps on the motherboard.
-
October 7th, 2009, 01:56 AM
#3
my code doesn't break, it only bends
-
October 7th, 2009, 02:29 AM
#4
Ok, so I tested the PSU with the paper clip method (one end in the green wire and the other in the black wire). The PSU came on with blue light and fan spinning. Does it REALLY prove that my PSU is alive and peachy? I was kinda hoping that its my PSU and not my mobo or something else. BUMMER!!!! PLEASE HELP.
my code doesn't break, it only bends
-
October 7th, 2009, 04:03 AM
#5
No. Just because it powers on, that doesn't mean the voltages/amperages are correct. I've seen PSUs pass "continuity" tests, but fail under load.
-
October 7th, 2009, 10:13 AM
#6
If you have, or can borrow, a multimeter, here's how to test the power supply:
Testing PSU Voltages
ATX Power Supplies
Trigger Power Supply for testing
In depth look at the power supply
Or alternatively you can buy a proper PSU tester, they don't cost much:
PSU Tester
ATX12V PSU Tester
But as Midknyte says, even that doesn't absolutely prove that it's good. I too have seen them pass those tests with flying colours, but still refuse to boot the PC.
Nick.
-
October 7th, 2009, 07:40 PM
#7
I went and bought a new PSU and it did the same thing as the old one. GRRRRRRRRRRRRRR!!!!
So I am going to have to return this $100 PSU.
Now, I started removing all the PCI-e and PCI cards, I had a few. That is to no avail. Then I removed the RAM and turned on the PSU. Still the same thing.
The last thing I did was remove the heatsink and PSU. Guess what, the PSU stays on, now. I haven't put the CPU back on yet but what does this mean????? Did my CPU die?
There is hardly any paste left on the CPU/heatsink join. Could this be an issue?
I need some advise as to whats next fairly quickly. THANK YOU!!!!!!!
You guys are AWESOME!!!!
my code doesn't break, it only bends
-
October 7th, 2009, 07:53 PM
#8
"There is hardly any paste left on the CPU/heatsink join. Could this be an issue?"
You bet it can be an issue. Clean all the old stuff off the CPU and the heatsink with alcohol and apply new thermal compound and make sure the heatsink is correctly installed.
Good luck
Biostar TA790GX A2+ 6.0
AMD Phenom X4 9750 CPU.
4 Gig DDR2 Memory.
ATI HD 5450 PCIe Video
ATI HD 5450 PCIe Video
500 Watt P.S.
LG W2241T Widescreen 22" LCD
ViewSonic VA721 17" LCD
Envision 17" LCD
2 LG DVD Drives
Floppy Disk Drive
Maxtor 120 Gig Windows 7 Home Premium 32 bit
Gateway NV5378-U Windows 7 Home Premium 64 bit
Acer Aspire V3-731 Windows 7 Home Premium 64 bit
-
October 7th, 2009, 09:11 PM
#9
Best instructions for using the paste.
http://www.arcticsilver.com/arctic_s...structions.htm
Just select you cpu.
When they say thin, we are talking paper thin too. >5/thousands of a inch.
-
October 7th, 2009, 10:13 PM
#10
Went to Radioshak and bought thermal grease. Applied it, put the heatsink back on. Doesn't do anything to the behavior.
I know that the compound is important but does it really have anything to with the problem at hand?
Agian, the problem at hand is when I turn on the PSU, the power comes on and off. Well, it just comes on once and thats it. It dies in a second. Is my CPU fried???
Last edited by masif; October 7th, 2009 at 10:42 PM.
my code doesn't break, it only bends
-
October 7th, 2009, 10:51 PM
#11
I have spent more time on it than it is worth. I am almost at a point where I am thiniking that may be I just need to replace the mobo or the CPU. Which one do you really think is the culprit here?
my code doesn't break, it only bends
-
October 8th, 2009, 12:30 AM
#12
Sorry that I'm getting in here late. I had a problem somewhat like yours years ago. The Motherboard went bad causing symptoms like yours. I wasn't sure what the problem was Motherboard or CPU. I decided to replace the CPU. More bad news, the Motherboard fried the new CPU too! I ended up replacing the CPU again and the motherboard this time too. Then the computer was back to normal. Guess what I'm saying is that if your not sure which one is causing the problem to replace both for fear of frying another CPU. If you have the proper equipment you can check them but that's usually the problem no equipment. BTW it's a very, very long story and I won't get into it, but it worked both ways and the CPU fried a second motherboard (this was very costly to me)!
1. Motherboard fried CPU (but I wasn't sure which was bad)
2. Old CPU didn't work with New Motherboard and fried New Motherboard(wasn't sure which was bad)
3. Bought New CPU, then New Motherboard (fried above #2) fried New CPU
4. Bought New Motherboard and New CPU again
Something shorted the Motherboard causing all of this with the original Motherboard & CPU. I had Arctic Silver 5 applied properly to the CPU so this wasn't the problem with mine. I wish you good luck with your computer.
Last edited by bugspop1; October 8th, 2009 at 12:54 AM.
Asus Zenbook Q508UG-212.R7TBL 2-in-1 Laptop
AMD Ryzen 7 5700U Processor
8gb DDR4 RAM (Soldered on Motherboard)
1gb Western Digital Blue NVMe SSD
NVIDA MX450 (DDR6)
15.6" 1920 x 1080 (Full HD) Touchscreen
Intel(R) Dual Band Wireless - AC 7260
USB 1 x 2.0 - USB 1 x 3.0 - USB-C 1 x 3.1
Micro SD Card Reader
Lighted Keyboard
Webcam/Microphone
Windows 11 Professional
MS Office 365 Family
Logitech Anywhere MX Mouse
-
October 8th, 2009, 12:42 AM
#13
^ Thats pretty scary. I hope I don't have to spend a lot of money.
Last edited by masif; October 8th, 2009 at 12:56 AM.
my code doesn't break, it only bends
-
October 8th, 2009, 12:44 AM
#14
If you haven't already done so, you could check the motherboard for bulging or leaking capacitors. If you find some, it is motherboard replacement time.
-
October 8th, 2009, 12:52 AM
#15
no bulging or leaking capacitors. That was one of the first things I checked actually.
my code doesn't break, it only bends
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|