Hi All!,
Just built a new system using the Asus A7V board with Duron 600. This board comes with onboard Promise ATA 100 capabilities. My Hard Drives are: Quantum Fireball,20Gig,7200Rpm LM(ATA66 compatible) as master. My second hard Drive is WD 10Gig,5400Rpm(also ATA66) as slave.
My question is,should i use the 40 pin/80 conductor cable and connect my drives to the ATA100 board connector? Or just use the standard 66/33 connector? The manual is pretty vague about how to set this up and whether or not i would gain from using it. My CD drives are: PLextor 8x4x32 CD-RW and Pioneer 16x DVD. Would any gain be realized if i use another 40/80 cable and connect these to the ATA100 secondary connector?
Any thoughts will be greatly appreciated.
Thanks Guys!

------------------
When in doubt,,pull the plug!!