During installation of Windows 7 64bit, there were no extra driver that was required for ICH10r. I setup in the BIOS to do ICH10R and then did a Control-I to set the RAID 0. After that, I just installed Windows 7. When Windows was done installing, I installed the Intel Rapid Storage Technology. Am I missing a step here?
What can I use to measure the Read Write speed of my SSD? HDTach will not work for Windows 7 64bit. The alternative is CrystalMark but not sure how to use it properly against RAID 0.
Does partitioning a RAID 0 hurt the performance? I read several articles that said partitioning to C and D drives will effect the performance.
Intel Rapid Storage Technology recommends a 16 kb for SSD. Is this correct base from the attached picture?
Last edited by Falcon Speed; May 14th, 2011 at 08:25 PM.
Originally wanted Millenium Falcon as nick but there is character limitation.
Falcon Speed = Millenium Falcon = Light Speed
Reply With Quote
