-
May 13th, 2020, 07:26 PM
#1
V7610 Netgear BUSINESS GATEWAY VPN pool ip address understand concept
Dear folk
https://www.telstra.com.au/content/d...tion-guide.pdf
I have got V7610 Netgear GATEWAY and I followed the attached document to setup Client to Gateway VPN page 5 and 6 says :
In the VPN remote virtual IP field, enter an IP address and mask and click Save. This is the range of IP addresses that the remote clients will be configured with when the VPN tunnel is set up. Note that this range must not be in the range of LAN IP addresses set up for the V7610 device "
I chose My gateway range of DHCP LAN ip address from 192.168.0.101-192.168.0.199.
1- How can I assign the VPN remote virtual IP say 192.168.0.52-192.168.0.80 same network but different range from the DHCP LAN ranges 192.168.0.101-192.168.0.199 ?
2- Snapshot below from the document above showing unique ip address been configured which is 192.168.16.1/24 ,,,,,Is this typo ? Shouldn't be 192.168.16.0/24 to refer to network address
https://imgur.com/a/xA9yH24
VPN is working ip addresses confused me
Thx
Thx
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|