Printable View
https://discussions.virtualdr.com/im.../2008/08/8.gif
But I would cover the side vents from the inside and see if that would help cooling. Did on my InWin S500 case. This diagram should give you a general IDEA of how the air should flow through the case.
http://www.compute-aid.com/atxspec.html
In reference to atx type questions. also a article on How do I test if the power supply is bad?
Hey Train,,thanks for the link,,lots of good info there.
My InWin full tower came out cooler with the last build when i removed the duct tape i had covering the panel vents. But,of course,those are located vertically at the front/sides of the case.
Did it for an experiment and when i fired it up,i used the phony smoke trick that's used to tell if you have insulation probs around door frames and such. It actually sucked the smoke "in".Telling me the lower front intake fan was causing a negative flow at the vents.
Even with the funky Asus Probe readings,it still seems to be running a' bit cooler than with them covered. Guess it depends on vent location/fan location as to how it goes?
I took and did a bunch of mods to the front intake area. :D
Well,,besides removing the tape,i guess i did what would be called a "mod" too.. I removed the funky plastic holder for the stock 80mm fan and case tweeter. Mounted a 90mm Enermax adjustable RPM fan directly to the metal after sawing out the Mickey Mouse perforations to give the air a clean flow.And insulated the fan frame from the case metal with small rubber "O" rings over the mounting screws. Also cut a 90mm hole in the plastic front cover and inserted a plastic duct with a green "scrubby" for a filter behind the metal grill... Works pretty well,,,so far...:)
Looking at the ASUS A7V333 Without raid $119.95
Supports AMD Duron/Athlon TB/XP
3 DDR Memory Slot/
5PCI slot / 1 4X AGP Slot
Ultra ATA-133
Built in Stereo Sound
Thought this might be a good replacement for the Compaq. It needs to retire. Not as expensive as the A7V266-E for some reason?
I added another fan (80mm) diagonally facing the plugin boards to help in the air flow you depict. Helps alot. :)
One thing I have learned from a old server case is you should have a little foam filter in the front of the case, it not only keeps your mobo clean, it will make opening you PC alot nicer!:D
^^^^ BUMP ^^^
My new case with fans:
There are two more fans slots on the other side panel. Two fan slots in the front of the case and two more on the back under the power supply.
I currently have 1-Fan blowing air out on the top of the case, 2 fans below the power supply blowing air out, two fans in the front of the case bringing air in, 1 fan on side panel blowing out and have three fans with a outside filter, mounted in the front (one of the 5.25 bays (between the cdrw and cd)} bringing air in.
This case really runs cool.
http://members.cox.net/joemurphy/Gif/case1.gif
Looks like a tornado generator to me :D
Actually with all them there fans, it's pretty quite, I used a brand BER Cooler case 80mm brushless sleeve bearing fans,
However, does sound like a blower when sitting next to it.... But CPU running cool:
800MHZ Celeron running at 34.8 C.
Not bad at all. Them 6k fans are a bit much. And is why I got the volcano 7 with the 80mm fan with a probe to adjust the rpm. 3668 and 51C with a xp1600. Room is about 86F/30C so not to bad. Knew the house was warm, but not that warm. :(
I just don't sit in front of the case may get sucked in.
My tower is enclosed within my computer desk (not a good idea,) but that is why I went to so many fans as there is restricted airflow around the case. I 've gotten use to the fan noice, quite soothing anyways....
Beats the sound of a freight train!
Let us see.
4 ea 80mm case fans
One in ps and of coarse the 80 on the hsf.
The hsf is quieter and cooler than the one it REPLACED
Case @ 30°C - CPU @ 49°C with the enclosed setup...
Basically I have airflow in a straight line from the 5.25 bay fan (80mm SUNON) through the HSF, and out right underneath the PS (another 80mm SUNON). Dropped the temps a good 5°C.
And the Volcano 7, replacing ther 6Cu+ helped in temps AND noise.
This is what I meant to show...
ahh home! home! home! ET go home!!!! cooling systems are like drugs to me.. like the side panel models. I prefer a full tower with ample room.
Noise? Noise? there are ear plugs or the vernerable headsets and play some music and get cell phone for calls! I bet I have more true cooling stories out there than anybody including adapting my monster custom cpu cooler! 32c forever? lol
www.plycon.com does some amazing stuff for cooling. (hope the link still works) lol..
mach
since you guys are on the subject, and I'm new to building.......I have a question about my case fans.......there are two, not counting heatsink and ps fans.......
At the moment, I can't even tell you what speed they run at, but looking at temps, last I saw it was holding at 32c........and like another in here, my puter sits inside a cubby hole.....although, there is ample space around it.......
Those other fans in my case........one in top of case, and one in the side of the case.......are run off power plugs on hdd/cd rom's........is that good?.....
photolady
Your in fine shape.
Thanks Train.....:).........
Keeping it cool. PhotoLady
Great temp....