Here's my dual boot problem...

I have a 13 GB hard drive. I made a 2 GB partition FAT16, and did nothing with the rest. I then installed NT4 on that partition. After this was done, I made the rest of the disk a single FAT32 partition and installed Win98SE.

My question is, is there a way to make this a dual boot easily with the boot.ini file? The only way I can change which one boots up right now is if I boot from a floppy just to get a command prompt, and use fdisk to change the active partition. At least, that's the only way I've found so far. I would think there would be a line I could put in boot.ini to make this easier. I'm just not sure of the syntax.

------------------
Go Devils!

http://www.xosl.org/

I've heard great things about it...looks like it will help your problem

------------------
Mark