Printable View
i have the case an d i have been trying to get the led light to come on .but i just cant not get it to work .
i did falow the motherboard manual how to plug the wire but still no go .this the case brand new .
APEVIA X-TROOPER Series X-TRP-GN Black / Green Steel ATX Mid Tower Computer Case.
this is the front light thank
The LED case lights have a + and a - wire. I assume you tried connecting the 2-pin connector rotated 180 degrees. Did you try connecting in place of a working LED to test to make sure that the LED is good?
i have one + and one-.
i did not rotat them 180 but 1/4 i did .
rigght nor i have the letter on the top .
bottom of the board facing up .
now i will take the dvd out and look and see if there is a led light in there .
if you take a really good look at the picture you will see a little red light at the lsft at the back of the front panel .
i do not have that small light there .
now i do not have the monitor plug in .is that make a difference .
i waithing for my expess 2 video cart because my new board do not have a video build in .my bad .
i will let you knoe in 10 minutes as soon as i take the dvd out .
ok got it .there is 2 light that i cant see up there .
the wire are green and white coming from the light .
so next i will turn the 180 like you said .
i let you know .
You cannot hurt an LED by connecting it with the wrong polarity, so if it doesn't work, just plug the connector in the other way, as JDC2000 said.
Where are you plugging the LED in to?
no go .i did rotat them .
but do i have to plug the - also or only the +
i do not see the - on the pin connection .
the board .i go by what the board manual show [diagram].
this is not a big deal but it be nice if i could get it light up .
on the board the is 2 + but i cant not see the - .
one thing my eyes are not the best .lol
this is my board giagram .Quote:
Originally Posted by yvesj
now do i need 2 +wire because it show 2 + and one -
Connect the LED between either of the +'s and the - of the PWR-LED pins.
thank .only the plus .
i only have one +.
one more thing i did not run the driver yet on the mobo is that could be the problem .my mobo only have a 9 pin male connector on it .so i cant connect my monitor yet till next week
just asking .
i did that about 10 time so far .Quote:
Originally Posted by SuperSparks
it is really easy there is only 3 pin to connect to
i guess i wait for next week to install vista and up date the mobo driver .
then i see what happen then .
i will let you know next week .
thank you
The failure of the power LED to activate has nothing to do with operating system.
According to your N68S3+ manual,
The coloured wire should be on either pin 12 or 13
and
The white wire should be on pin 14.