I was planning to give my 12 year old daughter my old 486dx2 50mhz which had been upgraded to 100 mhz pentium. I also had win 95 installed. The original o/s was win 3.1 for workgroups.

I am getting the following message when I turn the computer on:

Bad or missing C os\Emm386.exe
Error in Config.Sys line 4

I can't even get the c: prompt
Also, it states that my cdrom is installed however, it is not reading my cdrom. I am using Dos 6.20. Please help me!!

Also shows 1 cdrom drive(s) connected
cd rom device driver installed

LH C:\DOS\MSCDEX.EXE /D:MSCD0001/M:30/L
FILE NOT FOUND

C:\DOS\SMARTDRV.EXE 1024 512/X
BAD COMMAND OR FILE NAME

I used the master cd for the computer I am currently using which has windows 95 installed on it. Both computers are Packard Bell.

[This message has been edited by Patricia Flernoy (edited 12-31-99).]
I made a setup disk from my good system. Now I received a message stating "The compression driver cannot be set up correctly".

[This message has been edited by Patricia Flernoy (edited 12-31-99).]