October 18th, 2000, 06:36 PM
Error 41: Unable to bind (in NETBIND.COM)
I saw another question on here about netbind.exe, so I was hoping I could get some help with my problem too.
Here's the scoop:
I want to create a DOS boot disk to connect via DHCP through an Intel 32 bit PCMCIA NIC to an NT Domain using TCP/IP.
I currently have a working NETBEUI boot disk for the PCMCIA card.
I also currently have a working DHCP boot disk for some other ISA & PCI cards that connect me to my Domain via TCP/IP.
I have included what I hope will be helpful info and files below, autoexec.bat, config.sys, protocol.ini, system.ini
If anyone has a clue about how I should go about fixing this, I'd be forever grateful!
The following is the text I see when booting (parens show executing command):
Starting Windows 98...
Microsoft Protocol Manager version 2.1 (device=protman.dos /i:a:\NETWORK in config.sys)
Intel EtherExpress PRO/100 Mobile CardBus 32 NDIS v2.02 (980317) (device=a:\NETWORK\M32andis.exe in config.sys)
Copyright(C) 1998, Intel Corporation. All Rights Reserved.
Memory Address CC000, IRQ 10, Node Address 00A0C938E271
The command completed successfully. (NET INITIALIZE /DYNAMIC in autoexec.bat)
MS-DOS LAN Manager v2.1 Netbind (NETBIND.COM in autoexec.bat)
Microsoft Netbind version 2.1
Error: 41 Unable to bind.
NET0111: Error accesing NEMM.DOS. TCP 1.0 not loaded. (TCPTSR.EXE in autoexec.bat)
NET0111: Error accessing NEMM.DOS. Tiny RFC 1.0 not loaded. (TINYRFC.EXE in autoexec.bat)
Press any key to continue
Error 7361: (null) (NET START BASIC in autoexec.bat)
Here is my config.sys:
Here is my autoexec.bat:
NET INITIALIZE /DYNAMIC
NET START BASIC
Here is my protocol.ini:
Here is my system.ini:
October 19th, 2000, 07:46 AM
Does a:\network\nemm.dos exist and is it a good copy?
October 19th, 2000, 05:55 PM
Unfortunately, yes, it's the same copy that works on my other DHCP boot disk.
Thanks for your reply,
October 20th, 2000, 06:58 AM
Hmmm... mind's a blank this morning. (Needs more coffee! ). Have you tried posting this over in the Networking forum yet?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)