I just loaded NT on a MICRON 200 system. I tried the 3COM 3C509B, 3C509-tx and Novell Anthemm 2000 Compitable NICs. The software loads with a little of difficulty but loads. I reloaded NT 3 times with the same problem. The problem is that when I try to connect to the DOMAIN it says that "NO DOMAIN FOUND". On the 3COM, I ran Diagonistics and it says no card present. The Novell card when I run SOFTSET says the same. HELP.
You will need to find out exactly what card is in your system and get the driver for that card. To get past the 'No Domain' error, you can install NT using the MS Loopback adapter, then install the Network Card properly.
I have the proper divers, and installed them. The drivers are found at the 3com.com and are two disks. When the system was formated as win95 the adapter worked fine, but when I reformated it and put WINNT 4.0 and sp6 (I tried sp4 and sp5 also) the system either locks-up or just won't recognize the card or domain.