-
March 24th, 2020, 05:47 PM
#1
Cable Modem
My cable modem is a little over 3 years old. I am currently using the Arris Surfboard SB6190 DOCSIS 3.0 Gigabit Cable Modem. It was suggested/recommended in here back at that time and am pleased with it. I was recommended a number of hardware components of good quality over the years from others in here and was always very pleased with the suggestions. I am looking to purchase another cable modem, so I have a backup when my Arris dies. I would like another recommendation of a cable modem of good quality, speed, and specs that will see through the possible changes/improvements of cable internet in the future. Any recommendations would be appreciated.
-
March 24th, 2020, 06:40 PM
#2
You'd really need to check which modems are compatible with your ISP. Who is your provider and which data plan do you have?
Your modem is already at the high end of DOCSIS 3.0. You probably won't need a new modem unless you get a faster data plan. I don't think it'll be worth keeping another modem on the shelf now. DOCSIS 3.1 is only beginning to roll out, so it'll probably be worth it to wait.
-
March 25th, 2020, 12:22 PM
#3
My internet is through a local cable company in my area. The plan that I have is 100 Mbps download and 10 Mbps upload with 1500 GB per month. I contacted them and they said the only cable requirements for the modem would be DODSIS 3.0 or higher and minimum of 32 x 8 channel bonding. My last modem began to sporadically loose connection without dying completely when I had to replace it. I hope that is the same situation with my current modem so I am not without internet until I purchase a new one. I will wait until my modem shows signs of replacing. I appreciate the reply....stay safe, Midknyte. Thanx!
-
March 25th, 2020, 12:32 PM
#4
Heat and power issues are the things that kill modems and routers. If you do not have the modem (and any other router you are using) on a UPS, you should consider getting one to attach them to. I have all of my networking hardware on UPS systems.
Also make sure that you have decent cooling or ventilation for your networking components. Placing them in a closed cabinet or confined area where heat can build up can cause issues and shorten their life span.
-
March 25th, 2020, 02:21 PM
#5
32x8 minimum? I think that's overkill for just a 100Mbps plan, but that's fine.
I agree with jdc2000 that you should have your networking hardware (modem, router) on a UPS, and provide adequate ventilation.
-
March 25th, 2020, 03:32 PM
#6
And here's a 3rd agree.
-
March 29th, 2020, 04:52 PM
#7
JDC2000, thanks for that info. I don't have my modem and router in an enclosed space. I have a UPS, but don't have them connected to it. My UPS is not too close from my modem and router. I suppose I could use an extension cord to connect them to my UPS.
-
March 29th, 2020, 05:07 PM
#8
-
March 29th, 2020, 06:45 PM
#9
And do NOT use extension cords on a UPS.
-
March 30th, 2020, 10:57 AM
#10
-
March 30th, 2020, 12:15 PM
#11
Double ditto. Extension cords should not be used on a UPS. A separate small UPS is the way to go.
-
March 31st, 2020, 12:04 PM
#12
Thanks, SpywareDr.
Midknyte, I am glad I said I was going to use an extension cord in my post. I did not know that you shouldn't use them on a UPS. I appreciate that info.
Is that CyberPower UPS a good one or is there another brand/model that is superior to this one? I ran an Amazon review check on that Cyberpower page and the review rating did not come out that great meaning the many of the reviews posted are not reliable.
-
March 31st, 2020, 12:21 PM
#13
I have both CyberPower and APC UPS systems. Both should be decent quality. You can check the Newegg reviews for the same model also.
Extension cords have resistance, and suck power. Not a huge issue with AC power, but they would drain batteries and strain electronics on a UPS.
-
March 31st, 2020, 02:27 PM
#14
For a home networking UPS, I'd go with the Cyberpower over the APC in that price range. The smaller APCs don't have replaceable batteries, which means you have to buy a whole new unit.
It's against OSHA guidelines to use an extension cord with a surge protector or UPS. It's a fire hazard and you could damage your electronics.
-
April 1st, 2020, 07:38 PM
#15
JDC200, thanks for that info.
Midknyte, I will go with the Cyberpower APC. Again, I am so glad I posted about using an extension cord. I did not know that it could be a potential fire hazard. Thank you so much for this info, Midknyte.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|