-
January 14th, 2003, 10:00 AM
#1
Boots to C:\
I bought an IBM 390X from Ebay and need to know how to load win98SE onto it. It boots to C now. Do I need to get drivers for the CD Rom? Thanks
-
January 14th, 2003, 10:45 AM
#2
Installing W98 on TP 390X:
HERE
TP 390X Drivers:
HERE
There is a lot of other info available on your model there for you.
If you think AOL sucks just try MSN to see really bad service.
-
January 14th, 2003, 11:06 AM
#3
Think Pad 390X document page
Clcik F1 to enter BIOS
Scroll to Startup, Press [ENTER]
Select Power On
Select Network
Of all the things I've lost, I miss my mind the most
-
January 16th, 2003, 07:27 AM
#4
Kat,
for trying this you should have a working CD-ron drive, so the driver off course should be installed.
In your BIOS see where your boot-sequence is defined and set the option for CD-ROM at the top of the list. You might have to set a check mark in front of it. Be sure the CD-Rom is the only one to be "checked" (so remove the check from C).
After installation be sure to set the values back to the way they were before...
Hope it works!
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|