[RESOLVED] BIOS NOT LOADING

[Iced_Nardo]

Hi guys its me again, the computer was running perfectly well since I changed my VGA and PSU. Yesterday after playing Red Faction Guerrilla I switched off my computer and this morning turned on but somehow the computer got power but does not load the bios. The speakers are working and there is no beeps of any kind. I also connected my Corsair PSU onto a PSU Tester and shows as normal. I took the Mobo battery and the jumper out to clear up the CMOS and also tried changing the jumper to clear it up. Both hard drives have been connected to my external case and hooked up on my Laptop and no viruses were found. I also tried to unplug everything from my Mobo and connecting one by one to double check if would work. I tried all sets of connections to the motherboard and even only the power on it would not work. The computer has power because I see VGA light flashing when starts and all fans running with power. My case led lights are on but the hard drive is always off. I have a suspicious could be my Mobo or CPU but before rushing to conclusions I need to know to get a replacement under its warranty. I really appreciate for your help once again. Thanks!!!

[dneilson]

Try installing a new CMOS battery.

[SuperSparks]

Make sure that the ATX 12volt connector is plugged in, and test it with your tester, as you'll get the symptoms that you describe without that.

[Iced_Nardo]

Try installing a new CMOS battery.

Is it possible that a CMOS battery could have been causing that? It seems such a big deal for something so small like that. I just mean because the BIOS is not even showing up and no beeps whatsoever.

[dneilson]

Sure is possible. Whether something is small, large or medium has nothing to do with it--if anything is not what it's supposed to be it won't work. If you have a meter measure the voltage--should be 3 Volts.

[Iced_Nardo]

Sure is possible. Whether something is small, large or medium has nothing to do with it--if anything is not what it's supposed to be it won't work. If you have a meter measure the voltage--should be 3 Volts.

I am getting the battery in two days and I will keep it posted for any updates. Thanks Mate.

[dneilson]

OK--there's no guarantee this will fix your problem, but, as it's a possibility and they are so inexpensive it's worth a try. If it doesn't do it at least we can eliminate it from the troubleshooting.

[Iced_Nardo]

OK--there's no guarantee this will fix your problem, but, as it's a possibility and they are so inexpensive it's worth a try. If it doesn't do it at least we can eliminate it from the troubleshooting.

Hi there, just tried the battery today and it is not the problem. Nothing changed, the computer has power on it, i hear and see all fans blowing, vga flashing once power light when started. When I switch on my PC I also can see the DVD-rw drive flashing its lights like if its reading something than stops. I believe it is normal reading when starting. Funny thing no memory beeps nor BIOS. Could it be a dead CPU or MOBO??? Because both are still on the warranty but the problem is that I need to know each one is faulty. I have a guess might be the MOBO. Plz guys gimme some light about this.

[jdc2000]

Most of the time, it will be the motherboard that is faulty. If you were overclocking, then the CPU could have failed, if not then that is much less likely unless the heat sink and fan were not tightly attached.

[SuperSparks]

I agree, it is very rare for a CPU to fail. Motherboard failure, on the other hand, is distressingly common Unfortunately there is no way to be 100% certain, but on the balance of probabilities it is far more likely to be the mobo.

[bugspop1]

Does your Monitor show anything (like a VGA or DVI box or any other writing) moving around the screen? If you see a box like this if your monitor is OK. If you don't see a Box or writing the monitor might be the problem.

Can you hear the Hard Drive spinning? Put your ear up close to the Hard Drive to see if you can hear it spinning (make sure to have the computer turned on) (don't touch the hard drive)!

Is the Fan on Top of the Heatsink spinning? If not make sure it's plugged in to the motherboard s 3 pin connection marked for the heatsink fan. If it's plugged in, try another 3 pin connection on the motherboard!

If these three steps don't help, I'd go to the 15 steps below!

1. Unplugging everything including the Heatsink and CPU
2. Put CPU back into the CPU Socket
3. Apply small thin layer of Thermal Grease to the center of the CPU
4. Put Heatsink on top of the CPU and secure the heatsink (Plug in the heatsink's Fan to the motherboard)
5. Put 1 stick of RAM into the #1 Slot (usually nearest the CPU but check MB Manual for correct slot and also the number of Sticks RAM needed to power the computer) (make sure the tabs click into place holding the RAM in place)
6. Put your Video Card into the PCI-e slot (usually the one nearest the CPU but check the MB Manual to be sure)
7. Plug in any power connections needed for your Video Card (depending on the card it may need up to 2 power connections)
8. Put the Hard Drive back in the correct place inside your computer case, fasten with screws.
9. Plug in the SATA or IDE connection to your hard drive and then to the Motherboard (SATA 1 or IDE Primary)
10. Plug in a power connection to your Hard drive
11. Plug in the PSU's 2 connections to the motherboard (24 pin and 4 pin for newer computers) (1 x 20 pin for older computers)
12. Plug in Case Front Panel Connections to the Motherboard (Power SW, HD LED, Reset SW, Speaker etc...) (your external speakers will not usually beep if the Video Card or RAM isn't working properly so the Case Internal Speaker must be plugged in) (refer to your motherboard manual for connections)
13. Make sure your Case Fans are plugged in
14. Plug in Keyboard/Mouse, Plug in Power to the PSU and Wall, Plug in Monitor to the Video Card (VGA, DVI or HDMI) and Power Connection to the Monitor (then turn it on).
15. Once all of this is completed try starting the computer.
a. If it works Unplug Power then install 1 stick of RAM at a time starting the computer each time to make sure it still works.
b. If it doesn't work Unplug Power and Remove the RAM and replace with another stick. Plug in and restart to see if it worked.

[Iced_Nardo]

Does your Monitor show anything (like a VGA or DVI box or any other writing) moving around the screen? If you see a box like this if your monitor is OK. If you don't see a Box or writing the monitor might be the problem.

Can you hear the Hard Drive spinning? Put your ear up close to the Hard Drive to see if you can hear it spinning (make sure to have the computer turned on) (don't touch the hard drive)!

Is the Fan on Top of the Heatsink spinning? If not make sure it's plugged in to the motherboard s 3 pin connection marked for the heatsink fan. If it's plugged in, try another 3 pin connection on the motherboard!

If these three steps don't help, I'd go to the 15 steps below!

1. Unplugging everything including the Heatsink and CPU
2. Put CPU back into the CPU Socket
3. Apply small thin layer of Thermal Grease to the center of the CPU
4. Put Heatsink on top of the CPU and secure the heatsink (Plug in the heatsink's Fan to the motherboard)
5. Put 1 stick of RAM into the #1 Slot (usually nearest the CPU but check MB Manual for correct slot and also the number of Sticks RAM needed to power the computer) (make sure the tabs click into place holding the RAM in place)
6. Put your Video Card into the PCI-e slot (usually the one nearest the CPU but check the MB Manual to be sure)
7. Plug in any power connections needed for your Video Card (depending on the card it may need up to 2 power connections)
8. Put the Hard Drive back in the correct place inside your computer case, fasten with screws.
9. Plug in the SATA or IDE connection to your hard drive and then to the Motherboard (SATA 1 or IDE Primary)
10. Plug in a power connection to your Hard drive
11. Plug in the PSU's 2 connections to the motherboard (24 pin and 4 pin for newer computers) (1 x 20 pin for older computers)
12. Plug in Case Front Panel Connections to the Motherboard (Power SW, HD LED, Reset SW, Speaker etc...) (your external speakers will not usually beep if the Video Card or RAM isn't working properly so the Case Internal Speaker must be plugged in) (refer to your motherboard manual for connections)
13. Make sure your Case Fans are plugged in
14. Plug in Keyboard/Mouse, Plug in Power to the PSU and Wall, Plug in Monitor to the Video Card (VGA, DVI or HDMI) and Power Connection to the Monitor (then turn it on).
15. Once all of this is completed try starting the computer.
a. If it works Unplug Power then install 1 stick of RAM at a time starting the computer each time to make sure it still works.
b. If it doesn't work Unplug Power and Remove the RAM and replace with another stick. Plug in and restart to see if it worked.

Hi there, I have done all the steps you mentioned about and the PC is still not working. There is power on all components, CPU, Fans, HDs, VGA, etc. I have tested different memory sticks, took everything apart and put it back in. New thermal grease, cleaned all fans, basically everything that could have been done, I did. I strongly believe it is a Mobo problem and I am already on the process to get a new Mobo or a refund to buy a new one. Anyway, I promise to keep it posted and as soon as the computer is back running I will notify you guys about. Maybe this incident could help somebody else out there! Thanks mate!!!

[Iced_Nardo]

Most of the time, it will be the motherboard that is faulty. If you were overclocking, then the CPU could have failed, if not then that is much less likely unless the heat sink and fan were not tightly attached.

Hi I really never been into over clocking, I like to play it safe (lol). The computer just went half dead after some gaming session. I strongly believe is my stupid MSI Mobo. Thats why I am going back to ASUS. ;-)

[Iced_Nardo]

I agree, it is very rare for a CPU to fail. Motherboard failure, on the other hand, is distressingly common Unfortunately there is no way to be 100% certain, but on the balance of probabilities it is far more likely to be the mobo.

Yeah I agree with u , everything leads to a Mobo failure. I am not a professional technician but I have my leads about that as well. The way it happen I blame on my rubbish MSI Mobo. I have always been an Asus fan boy but somehow I got into MSI (I know they also make good stuff but after this will be a good time until I leave Asus behind again). Anyway thanks, I will keep it posted as soon as my new Mobo, AM3 CPU and Corsair Dominator Memories arrive. Thanks!!!

[SuperSparks]

Have a look at Gigabyte, IMO they are even a little better than Asus.